Tuesday, September 29th, 2009 at
7:55 pm
- 26-inch high definition TV with 720p resolution
- Three HDMI, one component, and one composite video input
- Improved picture with 30,000:1 dynamic contrast ratio, 8ms response time and Wide Color Enhancer 2 technology
- Two 5W bottom speakers and SRS TruSurround HD for a rich surround-sound experience from two speakers
- One-year parts and labor warranty
Product Description
26″ screen (measured diagonally) * widescreen 16:9 aspect ratio * high-gloss black finish * built-in digital (ATSC) and analog (NTSC) tuners for over-the-air TV broadcasts (antenna required) * built-in QAM cable TV tuner receives unscrambled programs without a set-top box (cable service required) * 1366 x 768 pixels *… More >>
Samsung LN26B460 26-Inch 720p LCD HDTV
Tuesday, September 29th, 2009 at
7:55 pm
Car window tinting is easier than you could have ever anticipated. Meticulously follow the bellow mentioned step to tint your car windows flawlessly ? Collect material that would be required for car window tinting before you start the process. Use the outside of your car window as a template and cut out sheets of the exact size. Ensure that you do that for all the windows in one go. Sticking one and going to cut sheet for the other is not the best way to go about it. Side windows need to be sprayed with a mixture of water and soap. Any residue should be removed by using a razor. A 4-inch squeegee could be used to get rid of residue. The residue needs to be pasted out of the film. Then the tint needs to be applied on the window. Ensure that you leave about 1/4 to 1/16 inch from the edge (top edge) as that part would get covered when the windows are rolled up and the door are closed. The tint then needs to be pressed into the inner rubber seal of the car window. A card can be used so that the film goes even to each and every corner. To ensure that the film is cleanly stuck, you should use a hand drier over the window. Make sure that you blow dry till the time there is no moisture content between the tint film and the glass. Then go for tinting the front car window in the same fashion. There after the back car window needs to be done, without skipping a single step. Then the number of defroster heater lines need to be counted on the back window. The rear window film sheet needs to be cut into the required panels. Place the panels one over the other. Where the two panels over lap identify the heater lines. Trim in case of defroster lines Moreover, you are good to go without spending a penny. Just ensure that step by step the process is followed.
About Author At the end, I’d like to share cool website with more information on topics like car window tinting and home window tinting. Visit for more details.
Tuesday, September 29th, 2009 at
7:54 pm
